![]() Step 2 Follow the step below to erase a static IP address and subnet mask. Note The erase nvram command does not erase a static IP address. Step 1 Enter erase nvram: to erase all NVRAM files including the startup configuration. If you want to erase everything including the static IP address, in addition to the above commands, use the erase and erase boot static-ipaddr static-ipmask command.įrom the privileged EXEC mode, you can reset the access point/bridge configuration to factory default values using the CLI by following these steps: If you want to reset the access point to its default settings and a static IP address, use the write erase or erase /all nvram command. Resetting to Default Settings Using the CLIĬaution You should never delete any of the system files prior to resetting defaults or reloading software. Resetting to Default Settings Using the GUI If you need to start over during the initial setup process, you can reset the access point to factory default settings.Resetting to Default Settings Using the MODE Button
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. Archives
January 2023
Categories |